company news about Principle of lubrication and replacement of parts of commercial mixing plant

If you want to make the concrete mixing station work more efficiently and use it more stable in the work, we usually need to know the maintenance and common sense of the mixing station; in order to extend the service life of the mixing station. According to the production and research of concrete mixing station for many years, the machine summarizes the details of how to lubricate the mixing station components and extend the service life of the mixing station system.

How to lubricate the mixing station components?

The shaft end seal of the mixer is refueled according to the regulations at the start of each main engine or timing to ensure the long-term normal operation of the oil seal structure; other fueling points such as rotating, rotating wheels and rails should be regularly refueled.

Extend the service life of the mixing plant system?

The mixing drum runs smoothly, the lining plate and the blade are not loose. If it is damaged, it will be replaced in time. When the lining plate, blade, scraper, mixing arm, etc. are worn to a certain extent or cannot be adjusted, it should be replaced in time. Timely or regular cleaning of the concrete in the mixer. When the concrete on the inner wall of the mixer becomes thicker and thicker, not only the volume of the mixer is reduced, but also the speed of the concrete is accelerated; the sanding material is due to the material. The bonding causes the door switch of the lowering port to be obstructed, and the cement feeding port is getting smaller and smaller due to the water-gas bonding, which makes the feeding difficult, so it is necessary to clean it regularly. The dosing line of the admixture may slow down the feed rate or cause blockage due to sedimentation and solidification, and it should be cleaned regularly.